Publicidad
EN
Locate and mark the position of the screws
Screw the flange and hollow out the liner
• The liner should be well-tensed. Continue with the installation until the water reaches 10 cm below the skimmer.
• Before continuing, make sure that the skimmer flap is well positioned.
• Mark the position of the fixing screws on the liner with a felt-tip pen.
• Position the second square flat seal (G) and the flange (F) against the liner, aligning the holes with the position marks of the screws.
• Fix the flange (F) on the liner with 10 TF screws 5 x 25 starting at the top. The pressure of fixing points on the liner should be constant, (fixing in cross)
• Cut the liner with a cutter from the inside of the skimmer.
• Now you should install the filter.
After finishing the fixing, hollow out the liner following the flange.
Look for us in our YouTube
channel to help you with
the assembly.
SKIMMER
Place the seal over the flange
Pool cleaner
connector
Skimmer basket
F
Skimmer cover
Connector tube
Base board of the pool
cleaner connector
Square flat seal
Skimmer basket
TB screw 5x25 stainless
steel
Skimmer cover
Vis TF 5 x 25 inox
Conenctor tube
Fig. 42
G
Liner
Flange trimming
Protection flange
83
Publicidad
