Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the Battery
Section 2
Total time to fully charge a dead battery is approx. 2.5 hours.
Before using your MAG-TAC®, place it in the charging base for at least one hour,
or until the LED indicator shows solid GREEN.
Your MAG-TAC® charger is compatible with PC USB ports. NOTE however,
charge times are slightly longer with a PC USB port than with the provided
MAGLITE® adapters.
DO NOT use any charging base, wall adapter, or generic battery charger other
than the ones provided with your MAGLITE®.
Make sure your light is Turned OFF (Mode 5) before inserting it into the
charging base.
Fault : Charger output is below the minimum threshold for normal operation.
Short circuit on charge terminals or component failure is detected.
Pre-Conditioning : Battery is dead. Base will charge battery at very low rate, it
will then proceed to Fast Charge.
Fast Charge : Base will fast charge the battery up to approximately 80%
capacity.
Top-Off : Battery is at 80% capacity, base will perform a slow charge until
battery is 100% capacity.
Maintenance/Idle : Charge is complete. The base will maintain a FULL charge
state. The flashlight is left in the base and as the battery voltage drops slightly
over time, the base will switch between Top-off and an idle state.
6
MAG-TAC
LED RECHARGEABLE- C
®
LED Indicator
Charger Mode
Blinking Red
Red
Pre-Conditioning
Orange
Fast-Charge
Blinking Green
Green
Maintenance
Green
Battery removal and replacement
(only necessary when battery has reached the end of service life)
1. Use battery nut wrench to unscrew battery nut. Install wrench into Barrel
(tailcap end) and twist until wrench locates into nut. Continue to turn wrench
counterclockwise until nut is fully unscrewed.
Note: if wrench is unavailable the new battery has a hex on the negative end that
can be used.
2. Remove battery from barrel.
3. Install new battery into the barrel with hex end first (negative end), toward the
head end of the light.
4. Install battery nut into barrel and use wrench to tighten nut. (can also use old
battery)
Note: use caution not to cross thread battery nut into barrel.
5. Screw tailcap back onto barrel.
B
F
HARGinG
AsE
unCTions
Battery State
Fault
Fault
Dead
Low
Top-Off
Partial Charge
Full Charge
Idle
Cradle Empty
Publicidad
