Maglite MAG-TAC LED Manual Del Propietário página 8

Operation
Section 3
Switch Operation
User input 'clicks' must be performed within 1 second of each other.
If your MAG-TAC® appears to go dim immediately after turning it ON, it
means your battery is almost dead. Charge it.
Rated Light Output is per ANSI specifications, with a fully charged
battery.
Rated Run-Time is per ANSI specifications, with a fully charged battery,
and with the light turned on and left on constant.
Notes:
DO NOT attempt to use any battery other than the one provided with
your MAGLITE®.
Make sure your light is Turned OFF (Mode 5) before inserting it into the
charging base.
When not in use, your MAG-TAC® Flashlight should be turned OFF and
left in the charging base.
MAG-TAC LED R
®
ECHARGEABLE
User Input
1 CLICK (hold) 1-Momentary ON
2 CLICKS 2-Latch ON
3 CLICKS 3-Power Save
4 CLICKS 4-Strobe
5 CLICKS 5-OFF / Charge
- F
unCTions
Mode
7