Pando TIB-2 Manual De Instalación página 38

EN - USE
• Commands luminous the key symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III and INTENSIVE or FOURTH SPEED.
F = AUTOMATIC STOP TIMER - 15 minutes (*)
If your appliance has the INTENSIVE speed function, from speed THREE, press key E for2 seconds
and it will be activated for 6 minutes after which it will return to the previouslyset speed. When the
function is active the LED flashes. To interrupt it before the 6 minuteshave elapsed, press key E again.
Some models allow activating this function even withspeed one and two.
By pressing key F for two seconds (with the hood switched off) the "clean air" function isactivated.
This function switches the appliance on for ten minutes every hour at the firstspeed. As soon as this
function is activated the motor starts up at the first speed for tenminutes. During this time key F and
key C must flash at the same time. After ten minutesthe motor switches off and the LED of key F
remains switched on with a fixed light untilthe motor starts up again at the first speed after fifty
minutes and keys F and C start toflash again for ten minutes and so on. By pressing any key for the
exclusion of the hoodlight the hood will return immediately to its normal functioning (e.g. if key D is
pressed the"clean air" function is deactivated and the motor moves to the 2nd speed straight away.
By pressing key B the function is deactivated).
(*) The "AUTOMATIC STOP TIMER" delays stopping of the hood, which will continuefunctioning
for 15 minutes at the operating speed set at the time this function is activated.
• Anti-grease/active charcoal filters saturation:
-When the A key flashes with a 2 second frequency the anti-grease filters must bewashed.
-When the A key flashes with a 0.5 second frequency the active carbon filters must bereplaced or
washed depending on the type of filter.
Once the clean filter has been put back one must reset the electronic memory by pressingthe A key for
approximately 5 seconds until it stops flashing.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGESCAUSED BY
BREACHING THE ABOVE WARNINGS.
35 - INOXPAN S.L.