Setup And Firmware Update; Warranty - Midland BTNEXT PRO Manual De Instrucciones

4. Press the "Backward" button shortly and the red light changes to a steady blue.
5. Now, press "Volume +" or "Volume -" to increase or reduce sensitivity. Every time
you press the Volume buttons the RED light will flash for confirmation. When you
reach the end of the upper and lower limit, the RED light will not flash.
6. Press again the "Backward" button shortly; the Blue light will flash several times, in
order to let you know the selected sensitivity:
One flash = VOX disabled
Twice = low sensitivity
3 times= normal sensitivity
4 times= high sensitivity
5 times = Highest sensitivity
The light indicator is now back to steady RED ("Set up mode") and the changes are
confirmed
7. If needed, you can adjust again the sensitivity repeating the steps from point 1,
otherwise exit the Setting mode by double clicking the "Middle" button. Once the
red light turns off, the blue led starts blinking. Now you can use your BTNEXT PRO
Disabling the VOX feature (Intercom and telephone)
Follow all the procedure described in the previous steps and choose the option of only
one flash (VOX disabled).
Attention! If you disable the VOX feature, you will be able to answer incoming phone calls
only by pressing the "Forward" button.
Wired connection always in background
This feature lets you keep the wired connection always on, even when the phone or the
intercom is open (but not when you are in FM radio mode).
By default the Background feature is ON.
Disabling:
› Enter the "Setup" mode:
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Press the "Forward" and "Middle" button together for 3 seconds. The blue LED will
flash three times.
34
› Double click on the "Middle" button to exit the "Setup" mode and use the BTNEXT
PRO
Enabling:
Follow the same procedure up described; now the blue LED will flash once.
To exit the "Setup" mode, double click the "Middle" button.

Setup and Firmware update

It is possible to configure and update the firmware of your Midland BTNEXT PRO using
the USB connection to your PC. On the Midland web site www.midlandeurope.com in
the Midland BTNEXT PRO page you can find the PC software and the new firmware
updates if available.
ATTENTION DO NOT CONNNECT THE UNIT TO THE PC BEFORE you
DOWNLOAD AND INSTALL THE SOFTWARE
Use at your own risk
The use of the device will impair your ability to hear other sounds and others around you.
Listening to music or speaking on a telephone may prevent you from hearing others
around you and distract you from riding safely. The use of such device while riding may
endanger you and others, and its use, in some areas, could not be allowed.
Using this device at a high volume may result in permanent hearing loss.
If you experience ringing in your ear or any other hearing related pain, reduce the vo-
lume or discontinue using this device. With continued use at high volume, your ears
may become accustomed to the sound level, which may result in permanent damage
to your hearing.
Please use this device at a safe volume level.

Warranty

The warranty lasts 24 months for the main device and 6 months for the accessories
(batteries, chargers, antennas, headsets, microphones). For further information about
the warranty, please visit www.midlandeurope.com.
www.midlandeurope.com