Publicidad
Idiomas disponibles
Idiomas disponibles
•
before checking, cleaning or working on
the blower.
•
if the blower starts to vibrate abnormally.
Operate the blower only in daylight or in good
3.
artificial light.
4.
Do not overreach and keep proper balance and
footing at all times.
5.
Never blow debris in the direction of bystanders.
6.
Operate the blower in a recommended position
and on a firm surface.
Do not operate the blower at high places.
7.
8.
Never point the nozzle at anyone in the vicinity
when using the blower.
9.
Never block suction inlet and/or blower outlet.
•
Be careful not to block suction inlet or
blower outlet with dust or dirt when oper-
ating in dusty area.
Do not use nozzles other than the nozzles
•
provided by Makita.
Do not use the blower to inflate balls,
•
rubber boat or the similar.
10. Do not operate the blower near open window, etc.
11.
Operating the blower only at reasonable hours
is recommended - not early in the morning or
late at night when people might be disturbed.
12. Using rakes and brooms to loosen debris
before blowing is recommended.
13. If the blower strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the blower
to stop it. Remove the battery from the blower
and inspect the blower for damage before
restarting and operating the blower. If the
blower is damaged, ask Makita Authorized
Service Centers for repair.
14. Do not insert fingers or other objects into
suction inlet or blower outlet.
15. Prevent unintentional starting. Ensure the
switch is in the off-position before inserting
battery, picking up or carrying the blower.
Carrying the blower with your finger on the
switch or energizing the blower that has the
switch on invites accidents.
16. Never blow dangerous materials, such as
nails, fragments of glass, or blades.
17. Do not operate the blower near flammable materials.
18. Avoid operating the blower for a long time in
low temperature environment.
19. Always be sure of your footing on slopes.
20. Do not use the machine when there is a risk of
lightning.
21. When you use the machine on muddy ground,
wet slope, or slippery place, pay attention to
your footing.
22. Avoid working in poor environment where
increased user fatigue is expected.
23. Do not use the machine in bad weather where
visibility is limited. Failure to do so may cause
fall or incorrect operation due to low visibility.
24. Do not submerge the machine into a puddle.
25. When wet leaves or dirt adhere to the suc-
tion mouth (ventilation window) due to rain,
remove them.
Maintenance and storage
1.
Keep all nuts, bolts and screws tight to be sure
the blower is in safe working condition.
If the parts are worn or damaged, replace them
2.
with parts provided by Makita.
3.
Store the blower in a dry place out of the reach
of children.
4.
When you stop the blower for inspection, ser-
vicing, storage, or changing accessory, switch
off the blower and make sure that all moving
parts come to a complete stop, and remove the
battery. Cool down the blower before making
any work on the blower. Maintain the blower
with care and keep it clean.
5.
Always cool down the blower before storing.
6.
When you lift the blower, be sure to bend your
knees and be careful not to hurt your back.
7.
Do not leave the machine unattended outdoors
in the rain.
8.
Do not wash the machine with high pressure
water.
9.
When storing the machine, avoid direct sun-
light and rain, and store it in a place where it
does not get hot or humid.
10. Perform inspection or maintenance in a place
where rain can be avoided.
After using the machine, remove the adhered
11.
dirt and dry the machine completely before
storing. Depending on the season or the area,
there is a risk of malfunction due to freezing.
12. Do not pick up or carry the machine by holding
only the cord.
Battery tool use and care
Prevent unintentional starting. Ensure the
1.
switch is in the off-position before connecting
to battery pack, picking up or carrying the
machine. Carrying the machine with your finger
on the switch or energizing machine that have the
switch on invites accidents.
2.
Disconnect the battery pack from the machine
before making any adjustments, changing
accessories, or storing machine. Such preven-
tive safety measures reduce the risk of starting the
machine accidentally.
3.
Recharge only with the charger specified by
the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of fire
when used with another battery pack.
4.
Use machines only with specifically desig-
nated battery packs. Use of any other battery
packs may create a risk of injury and fire.
5.
When battery pack is not in use, keep it away
from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from one
terminal to another. Shorting the battery termi-
nals together may cause burns or a fire.
6.
Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If con-
tact accidentally occurs, flush with water. If
liquid contacts eyes, seek medical help. Liquid
ejected from the battery may cause irritation or
burns.
3 ENGLISH
Publicidad
