Makita CBU01 Manual De Instrucciones página 6

To remove the end nozzle, perform the installation
procedure in reverse.
NOTE: The length of the nozzle can be changed by
moving the nozzle as shown in the figure.
1
► 1. End nozzle 2. Front pipe
Installing the flat nozzle or
extension nozzle
Optional accessory
1. Align the groove on the adapter pipe with the pro-
trusion on the front pipe, then attach the adapter pipe to
the front pipe, and then turn it to lock it into place.
1
► 1. Adapter pipe 2. Front pipe
2.
nozzle with the protrusion on the adapter pipe, then
attach the flat nozzle or extension nozzle to the adapter
pipe, and then turn it to lock it into place.
2
► 1. Flat nozzle 2. Extension nozzle 3. Adapter pipe
Installing the gutter nozzle set
Optional accessory
1.
trusion on the front pipe, then attach the adapter pipe to
the front pipe, and then turn it to lock it into place.
Insert the adapter pipe as far as it will go so that the
protrusion fits into the deepest groove on the adapter
pipe.
2
► 1. Screw 2. Hose clamp 3. Adapter pipe 4. Front
pipe
2.
the large hose clamp through the adapter pipe, and
then pass the small hose clamp.
6 ENGLISH
Align the groove on the flat nozzle or extension
1
2
Align the groove on the adapter pipe with the pro-
1
2
Loosen the screws on the hose clamps, and pass
3
4
3