ims PRO IMS SPOT 14500 TRAFO PRO Manual Del Usuario página 40

Idiomas disponibles

Press the

button for 2 seconds to get back to the NORMAL mode.

ERROR MANAGEMENT

Low battery

Invalid tool

Invalid arm

Current too low

IMS SPOT 14500 TRAFO PRO

In Manual mode, the maximum possible intensity is 8 kA for a maximum duration of 500 ms. The settings

showing on the screen will not exceed these values.

Set the generator by indicating the thickness of the sheet/panel to weld using + and - keys. It is possible to

adjust the current and time settings when in manual mode.

Various elements may produce errors. They can be split into 4 categories :

1/ Warning messages designed to warn the operator of overheating, lack of pressure or power, etc.

These messages are displayed on the screen and remain visible until a button is pressed.

2/ The faults that occur in relation to insufficient air pressure or power supply.

3/ The serious faults that block the machine. In this case, contact the service department

4/ The thermal protection is linked by a thermistance on the diode bridge and when it activates the

machine is locked and the message «overheating» is displayed.

The message «Battery low» is displayed when the machine is switched on and it indicates that the

battery on the command board is low. This battery is used to record the date and time when the

machine is switched off.

The message «Invalid tool» is displayed when the machine is switched on and indicates that a button

is pushed in, the trigger is pushed in or a permanent short-circuit. Check the trigger or the buttons on

the clamps to remove the message.

The arm used is not compatible with the welding mode selected.

1/ Check the weld

If the current obtained during a spot weld is lower than the expected value (6%), the machine dis-

plays the warning message «Low current, check the weld».

2/ Check the sheets

If the machine cannot deliver the current required, the error message «Low current, check the

sheets» is displayed. The weld does not happen and the fault must be skipped for the weld to happen.