Publicidad
Idiomas disponibles
Idiomas disponibles
Wear a dust mask (respiratory tract protection).
Wear protective gloves.
Wear foot protection.
Wear protective clothing.
ATTENTION! Electric shock warning!
ATTENTION! Loud noise warning!
ATTENTION! Beware of rotating cutting elements! Potential for injury!
ATTENTION! Hand crush hazard!
Only use indoors.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details may differ from the
actual product.
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Band saw
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching sockets reduces the
risk of electric shock.
b)
Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an increased risk of electric
shock if the earthed device is exposed to rain, comes into direct contact with a wet surface or is operating in a damp
environment. Water getting into the device increases the risk of damage to the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a socket. Keep the
cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of electric
shock.
e)
If working with the device outdoors, make sure to use an extension cord suitable for outdoor use. Using an extension
cord suitable for outdoor use reduces the risk of electric shock.
f)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power cord should be
replaced by a qualified electrician or the manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use the device on wet
surfaces.
h)
Do not use in very humid environments or in the direct vicinity of water tanks.
2.2.
Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents. Try to think ahead,
observe what is going on and use common sense when working with the device.
b) Do not use the device in a potentially explosive environment, for example in the presence of flammable liquids, gases or
dust. The device generates sparks which may ignite dust or fumes.
Publicidad
