Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.3.
Sawing
1. If necessary, adjust the table tilt.
2. Select rip fence and table tilt for the type of cutting operation to be carried out.
Danger by jamming workpiece! When using the rip fence with a tilted saw table, the rip fence must be installed on the lower
side of the working table.
3. Set upper blade guide 3 mm above the workpiece.
Always make a trial cut in a piece of scrap to verify settings; correct if necessary before cutting the workpiece.
4. Place workpiece on the working table.
5. Plug in.
6. Start saw.
7. Cut workpiece in a single pass.
8. Switch off if no further cutting is to be done immediately afterwards.
3.5.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or replacement of
accessories, or if the device is not being used.
•
Wait for the rotating elements to stop.
b)
Use only non-corrosive cleaners to clean the surface.
c)
After cleaning the device, all parts should be dried completely before using it again.
d)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
e)
Do not spray the device with a water jet or submerge it in water.
f)
Do not allow water to get inside the device through vents in the housing of the device.
g)
Clean the vents with a brush and compressed air.
h)
The device must be regularly inspected to check its technical efficiency and spot any damage.
i)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they may damage the
surface material of the appliance.
j)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or other chemical
substances because it may damage the device.
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a
clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time
you have finished using it.
A – Green „I" Button
B – Red „0" Button
Publicidad
