MSW -BS950S Manual De Instrucciones página 51

3.5.2. Adjusting the Blade Tension
This tracking adjustment is required to have the blade run dead center on the rubber tyres of the band saw wheels:
● Turning the setting knob clockwise increases the blade tension.
● Turning the setting knob counter – clockwise reduces the blade tension.
3.5.3. Band Saw Blade Alignment
If the band saw blade does not run in the centre of the rubber tyres, the tracking needs to be corrected by adjusting the tilt of
the upper band saw wheel:
1. Loosen locking nut.
2. Turn setting knob:
● Turn setting knob clockwise if the band saw blade runs towards the front of the saw.
● Turn setting knob counter- clockwise if the band saw blade runs towards the rear of the saw.
3. Tighten locking nut.