Descargar Imprimir esta página

Taurus CG4HN/B Manual Del Usuario página 22

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
When the power cord is damaged it must be replaced by the manufacturer to produce,
customer service agent or similarly qualified personnel.
GAS ADJUSTMENT:
Take precautions on the operations and adjustments to be carried out when converting from
one gas to another.
All work must be carried out by a qualified technician.
Before you begin, turn off the gas and electricity supply to the appliance.
1. Change the injector of the burners
Remove the pan support, burner lid and flame spreader.
Unscrew the injector using a 7mm box spanner and replace it with
the stipulated injector for new gas supply. Carefully reassemble all
the components.
After injectors are replaced, it is advisable to strongly tighten the
injector in place.
2. Adjustment of mínimum level of the flame
1. Turn the taps down to mínimum.
2. Remove the knob from the tap and place a small bladed screwdriver in the
centre of the tap shaft.
3. The correct adjustment is obtained when the flame has a length of about 3-4
mm.
- For butane / propane gas, the adjusting screw must be tightly screwed in.
- Refit the control knob.
Make sure that the flame does not go out by quickly turning from maximum flow to
minimum flow. If it does then remove the control knob and make further
adjustments to the gas flow, testing it again once the adjustment has been
made.
4. Repeat this process for each one of the gas taps.
Injector

Publicidad

loading