HAIRCUT TH34 Manual De Usuario página 27

4.6 Using the turbo function
Activating the Turbo function: press the Turbo button (Figure 1, D) to
increase the cutting speed and power by about 20%.
Disabling the Turbo function: press the Turbo button (Figure 1, D) again.
4.7 Switching off
Switch the clippers off by pressing the button (Figure 1, E). The red luminous
indicator integrated in the button and the "On" indicator icon (Figure 1, L) go out.
5 Servicing
5.1 Blades
Use the soft brush supplied to remove hair from the blades. Never rinse the
clippers with water. If necessary, use a cloth slightly dampened with water or
mild liquid soap. Never use abrasive products or solvents. The blades can be
cleaned with a STERIL CLEANER 920- and 921- antibacterial spray. Use this
cleaning product only. In the case of regular use, clean the blades at least once a
day.
Figure 8: Cleaning the cutters.
4. Use the cleaning brush (Figure 8, D) to remove hair from the gaps between
the fixed cutters (Figure 8, C) and the mobile cutters (Figure 8, A). Never
remove the cutters or their springs from the holder.
5. Apply 1 or 2 drops of lubricating oil on each of the 5 cutter lubrication points
(Figure 7).
1. Detach the blades by pressing
on the spot shown by the arrow
(Figure 6) with your thumb.
2. Use the cleaning brush supplied
to clean the blades.
3. Push the plastic holder (Figure
8, B) back with your thumb to
separate
(Figure 8, C) and the mobile
cutters (Figure 8, A) by about
2 mm.
27
the fixed cutters