BH FITNESS YS2000 Manual Del Usuario página 5

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES.
To fit the batteries, remove the rear
cover on the monitor, Fig.1, and
carefully insert the two "R-6" type
batteries into the battery compartment
(A) making sure that the battery's
polarity is correct
battery's «+» terminal with the «+»
sign inside the battery compartment,
and the «-» terminal with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important:
components in special containers Fig.2.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time and calories
burnt. Press MODE to change from
one value to another.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
Pressing the MODE key during 3
uses two 1.5
(matching
Deposit electronic
of speed,
English
seconds with the machine stopped will
reset the values except total distance.
volt
A. SCAN FUNCTION.-
In SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
the
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, values every 4
2. Press the MODE key and this will
cancel the SCAN function.
B.- TIME FUNCTION.-
This function counts up in steps of one
second to a maximum of 99:59
seconds.
C. SPEED FUNCTION.-
This function displays the speed in
km/h.
D. ODOMETER.-
This function shows you the total
accumulated distance that you have
travelled throughout the exercises.
To reset the total distance travelled
(ODO), take the battery cover off (A),
Fig. 1, and remove one of the
batteries to deactivate the monitor,
then replace the battery and the cover
(A), Fig.1.
NOTE:
automatically reset whenever the old
batteries are replaced with new ones.
5
mode the
The ODO function
computer
seconds.
will