Descargar Imprimir esta página

Aiwa NSX-A909 Manual De Instrucciones página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

3,4,5
5
4
1
Two microphones
(not supplied)
can be connected
to this unit,
allowing
you to sing along to music sources.
Use microphones
with mini plugs (03.5 mm,
1/8
inch)
1
2
3
4
5
Connect
your
microphones
to MIC 1 and MIC 2
jacks.
~
,@M,c,
Press
one of the function
buttons
to select
the
source
to be mixed,
and play the source.
Adjust
the volume
and tone of the source.
Press
MIC and turn VOLUME
within
4 seconds
to
adjust
the microphone
volume.
The microphone
volume
can be selected
from 1 to MAX (7)
or OFF (cancel).
The volume
of both microphones
is adjusted
simultaneously.
Press
ECHO and turn VOLUME
within
4 seconds
to adjust
the echo
level.
The echo level can be selected
from
1 to MAX (7) or OFF
(cancel).
To change
the delay
time of echo
Hold down ECHO while the echo is on.
"L" (Long)
and "M" (Middle)
are displayed
alternately.
At the
desired
position,
release
the button.
To record
microphone
sound
mixed
with source
sound
Follow the procedure
for recording
from the sound source
(see
page 17).
SYNC
DUB cannot
be used for mixing
recording.
When
not using
the microphones
Set the microphone
volume
and echo level to OFF and remove
the microphones
from MIC jacks.
m
When
the MIC or ECHO
level is changed,
the SURROUND
mode is automatically
canceled.
If a microphone
is held too near the speakers,
a howling
sound
may be produced,
In this case,
hold the microphone
away
from the speakers,
or decrease
the microphone
volume.
If sound through
the microphone
is extremely
loud, it may be
distorted.
In this case, decrease
the microphone
volume.
When the function
is changed,
the microphone
volume
and the
echo volume
are set to off.
21
ENGLISH
Recommended
microphones
The use of unidirectional
type microphones
is recommended
to
prevent
howling.
Contact
your local Aiwa dealer for details.
This unit can use discs or tapes as Karaoke
sources.
Use the Vocal fader function
for ordinary
discs or tapes.
Use the Multiplex
function
for multi audio discs or tapes.
Press
KARAOKE
repeatedly
to select
the vocal
fader
or
multiplex
function.
Each time
KARAOKE
is pressed,
one of these
functions
is
selected
cyclically.
@ Auto Vocal Fader
The singer's
voice becomes
softer only while there is audio
input through
a microphone.
@) Multiplex
Only
the
sound
on the
left channel
is heard
from
both
speakers,
and the sound on the right channel
is muted.
@ Auto Multiplex
The sound
on the left channel
is heard from both speakers,
and the sound on the right channel
is muted only while there
is audio input through
a microphone.
@
Cancel
To change
the time
lag setting
in Auto
Vocal
Fader
or
Auto
Multiplex
function
The muted
original
singer's
voice
can be turned
faster
to the
normal
level.
When Auto Vocal Fader or Auto Multiplex
is selected,
"A-W"
or
"A-MPX
is displayed
for 3 seconds
and changes
to the selsected
function
name. After the selected
function
name
is displayed,
hold down KARAOKE
until FAST is displayed.
To return to the initial setting,
select SLOW.
When the power is turned
off, SLOW
is restored.
To change
the audible
channel
in Multiplex
function
Only the sound
on the right channel
can be heard from
both
speakers.
When Multiplex
is selected,
"MPX-P
is displayed
for 3 seconds
and changes
to the selected
function
name. After the selected
function
name is displayed,
hold down KARAOKE
until MPX-R
is displayed.
To return to the initial setting,
select MPX-L.
When the power is turned
off, MPX-L is restored.
The
Karaoke
functions
may not operate
correctly
with the
following
kinds of CDs or tapes.
- Those with monaural
sound
- Those
recorded
with strong echoes
- Those with the vocal part recorded
on the right or left side of
the sound width
While
the Karaoke
function
is on, the sound
is output
as
monaural.
When the function
is changed,
the Karaoke function
is canceled.

Publicidad

loading