LEDs and Warning Indicator Description
During charging, the status LED will blink when the corresponding charging battery is
experiencing an abnormality due to the cable being disconnected, a high or low temperature,
overvoltage, or overcurrent. Once charging is complete, the status LED will be solid green. The
battery can be disconnected from the battery station.
Battery Station Status:
LEDs
Warning Indicator
/
Solid green
Solid
Solid yellow
yellow
/
/
Solid
Blinks yellow twice
yellow
continuously
Charging Indicators:
LED Blinking
Pattern
Solid yellow
Blinks green
Solid green
Blinks yellow once
continuously
Blinks yellow three
times continuously
Blinks yellow four
times continuously
Blinks red once
continuously
Blinks red twice
continuously
Beeps three times
Solid red
The warning indicator will light up if one of the following problems occur while using the battery
station:
Warning Indicator Warning Sound
Solid yellow
Blinks yellow once
continuously
Blinks red once
continuously
Power Button
Indicator
/
Solid green
Solid green
/
Warning Sound
The battery corresponding to the number is connected
/
/
The battery corresponding to the number is charging
/
The battery corresponding to the number is fully charged
/
The battery corresponding to the number is warming up
The temperature of the battery corresponding to the
/
number is too low and the battery station has stopped
The temperature of the battery corresponding to the
/
number is too high and the battery station has stopped
Beeps once
correctly connected or an unauthorized battery is
continuously
connected. This warning will only appear 10 seconds
Beeps twice
The connector short-circuited. Check the battery or the
continuously
continuously
/
Main board is abnormal and the power is limited
The CPX503-3000 switching power supply is abnormal
/
The CPX503-3000 switching power supply is unavailable
/
The battery station is ready to be activated, or
under loader stage
Self-diagnosis and power supply of the battery
station are normal
The battery station is ready to connect to a battery
The battery station logs are being exported and
it has stopped charging. Restart the battery
station after the logs have been exported
Description
and queued to charge
charging
charging
The battery in the corresponding position is not
after the battery is connected
battery station
Critical error detected
Description
and the power is limited
or the fan stalled
Description
©
2023 DJI All Rights Reserved.
7