cecotec BOLERO FLUX PM Manual De Instrucciones página 12

the backflow of combustion gases. These gases can cause
carbon monoxide poisoning. After installation of a kitchen
hood or other kitchen extractor fan, the operation of open
gas appliances must be checked by a competent person to
ensure that there is no backflow of combustion gases.
- The air discharge regulations must be complied with.
- The kitchen hood is intended for installation only over a hob
with four cooking zones.
- Important! Always disconnect the power supply during
installation and maintenance.
- The kitchen hood must be installed in accordance with
the installation instructions and in compliance with all
measurements.
- All installation work must be carried out by a competent
person or a qualified electrician.
- Dispose of the packaging material carefully. Children are
vulnerable to it.
- Pay attention to sharp edges inside the kitchen hood,
especially during installation and cleaning.
- Make sure that the duct does not have bends sharper than 90
degrees, as this will reduce the efficiency of the kitchen hood.
- Warning: Failure to install the screws or fastening device
in accordance with these instructions may result in
electrical hazards.
- Warning: Before accessing the electrical terminals, all power
supply circuits must be disconnected.
- If the rated voltage of the lamp is lower than the rated
voltage of the kitchen hood, the rated voltage of the lamp
shall also be marked on or near the lamp holder.
- When in extraction mode, the air in the room is extracted
12 BOLERO FLUX PM 906500 BLACK A / INOX A