Epson OT-CH60II Manual Do Utilizador página 8

Troubleshooting
❏
If the Charge LED does not light or flash, be sure that a battery pack is
attached firmly. If it is not attached firmly, charging cannot be done correctly.
❏
If the Charge LED keeps flashing, follow the steps below:
If the Charge LED flashes again, replace
the battery pack with an another one.
If the Charge LED flashes again, there
might be a problem in the battery charger.
Contact your dealer or Seiko Epson service center for advice on a
product that seems to have problems.
❏
If your printer does not operate correctly even if a sufficiently charged battery
pack is installed, the battery pack or the battery charger may be defective.
Contact your dealer or a Seiko Epson service center for advice.
8
Remove the battery pack that was being
charged and then reattach it.
If the Charge LED is lit and does not flash again
and the Charge LED goes off when the charging
time has passed, there is no problem.
If the Charge LED is lit and does not flash again
and the Charge LED goes off when the charging
time has passed, there might be a problem in the
previous battery pack.