Publicidad
SETTING THE CLOCK
When the AC cord is connected
for the first time, the II SET
button flashes.
Set the time as follows while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press
the
K
DOWN
or W
UP button
to
designate the hour.
Press the SET button to set the hour.
The hour stops flashing
and the minute starts flashing.
Press
the
M
DOWN
or W
UP button
to
designate the minute.
Press the SET button
to set the minute
and
complete setting.
The minute stops flashing
on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER
button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK
button on the remote
control.
The clock is
displayed
for 4 seconds.
However,
the time cannot
be displayed
during recording.
To
switch to the 24-hour standard
Press the CLOCK
button on the remote control and then press
the W button within 4 seconds.
Repeat the same procedure
to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current
time needs
to be reset,
If power is interrupted
for more than approximately
24 hours, all
settings
stored in memory
after purchase
need to be reset.
14
Publicidad
