Publicidad
TROUBLESHOOTING
GUIDE
If the unit fails
to perform
as described
in these operating
instructions, check the following guide,
GENERAL
There
is no sound.
Is the AC cord connected
properly?
Is there a bad connection?
(+ page 8)
Is there a short circuit in the speaker
terminals?
+ Disconnect
the
AC cord,
then
correct
the
speaker
connections.
Is an incorrect
function
button pressed?
Sound is emitted from one speaker only.
Is the other speaker
disconnected?
The output sound is not stereo.
0 Is
the Karaoke
function
turned on? (+ page 48)
An erroneous
display or a malfunction
occurs.
+
Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
Is
the antenna
connected
properly?
(+ page 8)
Is the signal weak?
+ Connect
an outdoor
antenna.
The reception contains noise interferences
or the sound
is distorted.
*
Is the system picking up external
noise or multipath
distortion?
+ Change
the orientation
of the antenna.
+ Move the unit away from other electrical
appliances.
CASSETTE
DECK SECTION
The tape does not run.
Is deck 2 in pause mode? (+ page 30)
The sound is off-balance
or not adequately
high.
Is the playback
head dirty? (+ page 58)
Recording
is not possible.
Is
the erasure
prevention
tab on the tape broken off? (+ page
32)
Is the recording
head dirty? (+ page 58)
Erasure is not possible.
Is
the erasure head dirty? (+ page 58)
Is a metal tape being used? (+ page 34)
High frequency sound is not emitted.
Is a tape recorded without Dolby NR played back with the Dolby
NR system
operating?
(+ page 30)
Is the recording/playback
head dirty? (+ page 58)
CD
PLAYER
SECTiON
The CD player
does
not play.
Is the disc correctly
inserted?
(+ page 24)
Is the disc dirty? (+ page 58)
Is the lens affected
by condensation?
+ Wait approximately
one hour and try again,
To reset
If an unusual
condition
occurs
in the display
window
or the
cassette
decks,
reset the unit as follows.
1
Press the POWER
button to turn off the power.
2
Press the POWER
button
to turn the power
back on while
pressing
the
CLEAR button.
Everything
stored in memory
after purchase
is canceled.
If the power
cannot
be turned
off in step
1 because
of a
malfunction,
reset by disconnecting
the AC cord and repeat step
2.
64
Publicidad
