Publicidad
1
1
\'
J
2
REV MODE
3
UINR
b
5
rEEpl
RECIREC MUTE
BASIC RECORDING
This section explains how to record from the tuner, CDs, or
external equipment. If you want to record from tapes, see pages
36 to 38.
Preparation
Wind up the tape to the point where recording will start.
Use normal (type I) and Cr02 (type
II)
tapes for recording.
Insert the tape to be recorded on into deck 2.
Insert the tape with
the side to be recorded first facing
the foreground and the exposed side down.
Press the REV MODE button to select the reverse
mode.
To record on one side only, turn on ~.
To record on both sides, turn on => or ~=).
Press
the
DOLBY NR button to turn Dolby NR on
or off.
To record with DOLBY NR, turn on
U NR.
To record without DOLBY NR, turn off DU NR.
Press
one
of the function
buttons
and
prepare
the source
to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected source, press the VIDEO/
AUX button and play.
Press the
REC/REC
MUTE button
to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press the
button.
To pause recording, press the II button. (Applicable when the
source is TUNER, VIDEO/AUX.)
To resume recording, press
again.
To start recording with the remote control
First press the ./0
REC/REC MUTE button, and then press the
4>
button within 2 seconds.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables activation of the
Music Sensor function. (Applicable when the source is TUNER
or VIDEO/AUX.)
1
Press the
REC/REC MUTE button during recording or
while in recording pause mode.
-
on the display flashes for 4 seconds and the tape
runs without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while _
is flashing.
To insert blank spaces of more than 4 seconds,
after the
deck enters recording pause mode, press the
REC/REC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
34
Publicidad
