Publicidad
2
TUNING
W
DOWN
uPWf
MONO
MANUAL TUNING
1
2
Press the TUNEFUBAND button to select the band
repeatedly.
If the power is turned off, the previously
tuned station will be
played (Direct Play Function).
n
Press the M
DOWN or H
UP button to select
a station.
Each time the button is pressed,
the frequency
changes.
When a station is received, 'TUNE
is displayed for 2 seconds.
During FM stereo reception,
ii(m)))is displayed.
To search for a station quickly (Auto Search)
Keep the W
DOWN or FM UP button pressed. until the tuner
starts
searching
for a station.
After tuning
in to a station,
the
search stops.
To stop the Auto Search manually, press the M
DOWN or M
UP button.
The Auto Search
may not stop at stations
with very weak
signals.
When an FM stereo broadcast contains noise
Press
the MONO
TUNER
button
to display
"MONO"
on the
display. +
Noise is reduced,
although
reception
is monaural.
To restore
stereo
reception,
press the button
so that MONO
disappears.
To
change the AM tuning interval
The default setting
of the AM tuning interval
is 10 kHz/step.
If
you use this unit in an area where the frequency
allocation
system
is 9 kHz/step,
change the tuning interval
as follows.
Press
the POWER
button
while
pressing
the TUNER/BAND
button.
To reset the interval,
repeat this procedure.
When the AM tuning
interval
is changed,
all preset
stations
(see page 22) are cleared.
The preset stations
have to be set
again.
20
Publicidad
