Kenwood HMP 34.AOWH Instrucciones página 8

Metal Bowl (TYPE HMP34 only)
Never use a wire brush, steel wool
or bleach to clean your stainless
steel bowl. Use vinegar to remove
limescale. Keep away from heat
(cooker tops, ovens, microwaves).
Before plugging in
Make sure your electricity supply is the same as the one shown
on the rear of your Handmixer.
This appliance conforms to EC Regulation 1935/2004 on
materials and articles intended to come into contact with food.
Before using your Handmixer
for the first time
Wash the parts (see 'Care and
cleaning').
Key
Tool release button
1
Speed selector
2
(P) Pulse button
3
Mixer
4
Beater
5
Beater with gear
6
Kneader
7
Kneader with gear
8
Mixing bowl
9
Cradle
10
Mixer release button
11
Cradle release button
12
Stand
13
To Use your
Handmixer
Refer to illustration
Fitting the beaters/kneaders
Insert the beater/kneader with
the plastic gear in the
A
socket.
4
Setting Up the Bowl
& Stand
Refer to illustrations
1 Fit the beaters/kneaders to
the Handmixer.
2 Hold the front of the cradle
and raise by pressing the
cradle release button.
3 Place the bowl onto the stand.
4 Fit the mixer to the cradle and
push down to secure.
Note: Check that the beater/
kneader with the plastic gear
aligns with the drive gear on
the cradle.
5 Lower the cradle by holding
the Handmixer handle whilst
pressing the cradle release
button at the same time.
6 Plug in and select a speed
(Refer to the recommend
usage chart).
After Use
Refer to illustrations
1 Switch the speed selector to
the 'O' OFF position.
2 Hold by the handle and lift
up the cradle by pressing the
cradle release button.
3 Remove the mixer from the
cradle by pressing the mixer
release button and lifting off.
A E
–
F H
–