Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
TO AVOID S ERIOUS
INJURY,
BEFORE PERFORMING
ANY SER-
VICE OR ADJUSTMENTS:
1. Depress brake pedal fully and set parking brake.
2. Place attachment clutch in "DISENGAGED" position.
3. Turn ignition key to "STOP" and remove key.
4. Make sure the blades and all moving parts have completely stopped.
5. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE MOWER
1. Place attachment clutch in "DISEN-
GAGED" position.
2. Lower attachment lift lever to its lowest
position.
3, Roll belt off engine pulley (M) and belt
keepers ((3),
4. Remove retainer spring (K), slide collar
(L) off and push housing guide (P) out
of bracket.
5. Remove clutch cable spring (Q) from
idler arm (R).
6. Disconnect front link (E) from mower -
remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension arm (A) from
chassis pin (B) and rear lift link (C) from
rear mower bracket (D) - remove retainer
springs and washers.
CAUTION: After rear lift links are discon-
nected, the attachment lift leverwill be spring
2.
loaded. Have a tight grip on lift lever when
,
changing position of the lever,
8. Slide mower out from under right side of
tractor,
IMPORTANT: If an attachment other than
the mower is to be mounted on the tractor,
remove the front ]ink (E) and rear lift links
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO INSTALL MOWER
Besuretractor ison level surfaceandengage
parking brake.
1. Lower attachment lift lever to its lowest
position.
_lb CAUTION: Lift lever is spring loaded.
Have a tight grip on liftlever, lower it slowly
and engage in lowest position.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before sliding
mower under tractor.
Slide mower under tractor until it is cen-
tered under tractor.
21
Publicidad
