Bestway 43728 Manual Del Usuario página 9

• ATTENTION! NO PROTECTION AGAINST DROWNING!
• SWIMMERS ONLY!
• Evenly distribute loads when use the product. Tipping and drowning may occur with uneven distribution of
loads.
• Non-compliance with these operating instructions may expose you to serious danger. Only use the product in
the places and conditions for which it is intended.
SAVE THESE INSTRUCTIONS
TECHNICAL SAFETY INSTRUCTIONS
• Fully inflate all air chambers.
• This is not a life-saving device. Do not leave children unattended while device is in use. Competent adult
supervision should always be provided.
• Do not overload; always wear an approved personal flotation device (life preserver).
• Life saving devices (life jacket and life buoy) must be prepared together and inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product components to ensure everything is in good condition and
tightly secured. Please stop and make repairs if you find any damage.
• Be careful when placing product on the ground. Sharp and rough objects such as rocks, cement, shells, glass,
etc. may puncture the product.
• Don't leave the product exposed to sun for long periods of time. Otherwise, the product material is likely to
stretch and or change shape. This can cause irreparable damage.
• Never leave in or near the water when not in use.
• Never use in stormy weather, or in rough conditions. Seek shelter when lightning is present, DO NOT stay on
the product.
• Use in calm shallow waters near the shoreline.
• Never allow diving to or from this product.
• Do not use for navigational purposes such as a boat. This is not a boat.
• For your own safety, always heed the advice and warnings in these instructions.
• Know and follow local water safety rules and regulations.
INFLATION AND ASSEMBLY
WARNING: Adult assembly required.
1. Take the island and accessories out with care. Spread the island out.
2. Open safety valve and inflate with the air pump (not include) to design working pressure on the product.
3. Fill the chambers until most of the wrinkles are gone and it feels firm to touch but NOT hard. If you use a
pressure gauge (not included), the pressure should not exceed the specified pressure on the product or in
the instructions. Do not over-inflate the product. Only use a low-pressure air pump. Do not use an air
compressor.
NOTE: Under and over-inflation of the product will result in safety hazards. It is better to check the pressure
of the product each time before using.
4. Be sure to close the valves after inflation, press in the safety valves after inflation.
NOTE: Never stand on or rest objects on the product during inflation.
DEFLATION AND DISMANTLING
• Open and pinch the bottom of the valves to deflate.
MAINTENANCE AND STORAGE
1. After use, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may damage the product.
2. Store in a dry place, with a temperature higher than 15ºC/59ºF, out of reach of children.
WARNING
9