Publicidad
Idiomas disponibles
Idiomas disponibles
PURGE TRANSMISSION
_IbCAUTION:
Never engage or disengage
freewheel lever while the engine is running,
Toensure properoperation and performance,
it is recommended that the transmission be
purged before operating tractor for the first
time. This procedurewill remove any trapped
air inside the transmission which may have
developed during shipping of your tractor.
IMPORTANT:
Should your transmission
require removal for service or replacement,
it should be purged after reinstallation before
operating the tractor.
1, Place tractor safely on a level surface -
that is clear of objects and open - with
engine off and parking brake set.
2. Disengage
transmission
by placing
freewheel control indisengaged position
(See "TO TRANSPORT" in this section
of manual).
3, Sitting in the tractor seat, start engine.
After the engine is running,move throttle
control to slow position, Disengage park-
ing brake.
_IbCAUTION: At any time, during step 4,
there may be movement of the ddve wheels.
4, Depress forward ddve pedalto fullforward
. position and hold forfive (5)seconds and
release pedal, Depress reverse drive
pedal to full reverse position and hold
for five (5) seconds and release pedal.
Repeat this procedure three (3) times.
5. Shutoff engine and set parking brake.
6, Engage transmission by placing free-
wheel control in engaged position (See
"TO TRANSPORT"
in this section of
manual).
7. Sitting in the tractor seat, start engine,
MOWING TIPS
• Tire chains cannot be used when the
mower housing is attached to tractor.
• Mower should be properly leveled for best
mowing performance.
See "TO LEVEL
MOWER HOUSING" in the Service and
Adjustments section of this manual.
• The left hand side of mower should be
used for trimming,
• Drivesothatclippings are discharged onto
the area that has already been cut. Have
the cut area to the right of the tractor. This
will result in a more even distribution of
clippings and more uniform cutting,
• When mowing large areas, start by turning
to the right so that clippings will discharge
away from shrubs, fences, driveways,
etc, After one or two rounds, mow in the
oppositedirection making left hand turns
until finished,
• If grass is extremely tall, it should be
mowed twice to reduce load and possible
fire hazard from dried clippings,
Make
first cut relatively high; the second to the
desired height,
• Do not mow grass when it is wet. Wet
grass will plug mower and leave undesir-
able clumps. Allow grass to dry before
mowing.
After the engine is running, move throttle
8, Drive tractor forward for approximately
five feet then backwards for five feet,
Repeatthisdriving procedurethreetimes.
Your transmission is now purged and now
ready for normal operation.
...................
,.,_,,_= ÷,_-h=[{t_/m. _,_4.
r_ ................ ,.Always
operate engine at full throttle
parking brake.
"
wi_en mowirigt0assi_re
betterm0w:
.....
ing performance and proper discharge
of material. Regulate ground speed by
selecting a low enough speed to give the
mower cutting performance as well as the
quality of cut desired.
• When operating attachments, select a
ground speed that will suitthe terrain and
give best performance of the attachment
being used.
15
Publicidad
