Publicidad
Idiomas disponibles
Idiomas disponibles
THINK
SAFETY
Safety is a combination of operator common sense and alert-
ness at all times when the saw is being used.
Never use another person as a substitute for a table exten-
sion, or as additional support for a workpiece that is longer or
wider than basic saw table, or to assist in feeding, supporting
or pulling the workpiece.
Do not pull the workpiece through the saw blade--position
your body at the infeed side of the guard; start and complete
the cut from that same side. This will require added table sup-
port for long or wide workpieces that extend beyond the
length or width of the saw table.
CAUTION:
Follow safety instructions that appear on the front
of your saw.
Refer to Figure 2.
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Check for shipping damage. If damage has occurred, a claim
must be filed with carrier. Check for completeness.
Immediately report missing or damaged parts to Sears at 1-
800-4-MY-HOME
(1-800-469-4663).
The saw is shipped complete in three crates. The table saw
comes assembled as one unit in the first carton. Additional
parts which need to be fastened to the saw should be located
and accounted for before assembling:
A
Table Extension (2)
B
Cabinet Door
C
Miter Gauge Assembly
D
Blade Guard Assembly
E
Support Rod and Bracket Guard
F
Locking Knob (2)
G
Handwheel and Crank Handle Assembly (2)
H
Arbor Wrench
I
%" Arbor Nut (228030 only)
J
%" Blade Flange (228030 only)
K
Dado Insert Assembly
L
T-Blocks (2) with 6-1.0 x 20mm Socket Head Bolt
M %" Arbor (228030 only)
N
%" Dado Arbor
O
10-1.5 x 35mm Hex Head Bolt with Lock Washer (6)
NOTE: 1" Arbor, Nut and Flange are installed on
228030 12" Saw. %" Arbor, Nut and Flange are installed
on 228050 10" Saw.
The second carton contains:
P
Rip Fence Assembly
Q
Front, Rear and Guide Rails
Scale (not shown)
Hardware Bag (not shown), P/N 23135.00
C
O
B
D
,/
R
Figure 2 - Unpacking
IMPORTANT: Table is coated with a protectant. To ensure
proper fit and operation, remove coating. Coating is easily
removed with mild solvents, such as mineral spirits, and a soft
cloth. Avoid getting solution on paint or any of the rubber or
plastic parts. Solvents may deteriorate these finishes. Use
soap and water on paint, plastic or rubber components. After
cleaning, cover all exposed surfaces with a light coating of oil.
Paste wax is recommended
for table top.
WARNING:
Never use highly volatile solvents. Non flamma-
ble solvents are recommended
to avoid possible fire hazard.
The third carton contains:
R
Extension Table
S
Support Bar
T
Legs (2)
Hardware Bag (net shown), P/N 22061.00
Refer to Figures 3-11, pages 6, 9 and 16-26.
CAUTION:
Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Be certain all parts are clean and free of shipping preserva-
tive. Also, completely
remove all parts of crate and packing.
Saw cabinet should be directly on the floor.
Publicidad
