5. Avoid areas where the appliance would be exposed to direct sunlight, sources of heat (stove, heat-
er, radiator, etc.), extremely cold ambient temperatures or excessive moisture and high humidity.
Installing it in the coolest area of the room will save energy consumption and running costs.
Handle with care! Do not apply force to any area such as the condenser or the door. The metal rails on
the bottom of the refrigerator may have sharp edges, so always unpack and handle with care. Do not
drag the unit: place it carefully into position to avoid scratching the floor.
• Place the unit so there is enough space for the door to open.
• Leave a minimum clearance of 100mm at the back of the fridge to ensure air can circulate freely
so the compressor and condenser can cool down. Also leave at least 50mm of space at the top of
the fridge and 50mm on each side.
• The appliance must be level in order to work properly. If the unit is not level, the doors and magnetic
seal alignments will not be covered properly.
• Your refrigerator has two adjustable front feet, one on the right and one on the left. In most cases, the
refrigerator should be steady when both feet are touching the floor. If your refrigerator seems un-
steady or if you want the doors to close more easily, adjust the refrigerator's tilt by levelling the feet.
A DJUSTIN G TH E THE RMOSTAT
• To start the refrigerator, turn the thermostat knob to the position corresponding to the desired
temperature. The temperature of the refrigerator is controlled by adjusting/setting the thermo-
stat knob, located at the top of the cabinet.
• The settings 0(OFF) - 7(MAX) regulate the internal temperature of the refrigerator.
Setting 0 (OFF): not operating (Please press the knob and turn to get the "0" position).
Setting 1 (Min.): lowest setting (warmest internal temperature).
Setting 7 (Max.): highest setting (coldest internal temperature).
NOTE: The refrigerator temperature will vary depending on the quantity of cans/bottles stored and
on the frequency with which the door is opened. The internal temperature varies in different parts
of the refrigerator. The back of the refrigerator is coldest. Please keep the cans/bottles away from
the rear wall to avoid them freezing and to allow cold air circulation.
NOTE: The thermostat 0 (OFF) position indicates that the refrigerator is turned off even though
power is still being supplied to the appliance. By turning the thermostat knob to the left, the refrig-
erator will turn on automatically. When the refrigerator is not going to be used for a long period of
time, disconnect the plug and leave the door partially open.
8
E N G LI SH
SPACE REQUIREMENTS
LEVELLING
Light
Thermostat