Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
REMOVE LOWER HINGE
12
(if necessary) (on some models)
Remove screws that secure hinge to the cabinet.
RE-INSTALL CONVERTIBLE
13
DRAWER
To reassemble doors, reverse removal steps.
Convertible drawer basket will be loose if re-installed
re-installation.
REPLACE FREEZER DRAWER
14
CAUTION
Lifting Hazard
Freezer door is heavy Use both hands to secure
the door before lifting.
1. Pull the lower basket slide mechanism to full
extension with both hands.
notches on the slide mechanisms. NOTE: Place
one side in first, then align the other side.
3. Replace the attachment screws and torque the
screws to 65 in-lb (7.34 N-m).
49-1000713 Rev. 1
15
3. Check for smooth operation of baskets.
16
instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and
property damage.
A single person lift could cause injury. Gain
assistance when handling, moving, or lifting
refrigerator doors.
1. Reinstall lower hinges first (if necessary) and torque
hook and slide
mechanism notch
2. With the door at 90° to the front of the case, lower
3. Reinstall the center hinge per step #1 above.
4. Remove the tape.
5. Open the lower right-hand door 90°.
6. Connect the two harnesses.
7. Replace both lower hinge covers (if necessary).
RE-INSTALL FREEZER BASKETS
drawer wheels onto the top of the tracks on the
basket.
REINSTALL LOWER LEFT AND
RIGHT-HAND DOORS
WARNING
CAUTION
Lifting Hazard
screw to 25 in-lbs (2.82 N-m). Rotating the screw
by 1/3 turn after it is flush with mating surface will
achieve these torques.
the refrigerator door onto the lower hinge, carefully
pulling the harness through the right-hand hinge.
Close the door and tape closed.
(on some models)
31
Publicidad
