Bosch NGM Serie Manual De Uso Y Cuidado página 8

2
3
I
4
1 2 3 4 5 6 5
Figure 3: Model NGM5654UC / NGM5624UC / NGM5664UC / NGM8654UC
1. Left front surface burner (12,000 BTUs)
2. Left rear surface burner (12,000 BTUs)
3. Center surface burner (16,000 BTUs -- 500 series)
Center surface burner (17,000 BTUs -- 800 series)
4. Right rear surface burner (5,500 BTUs)
5. Right front surface burner (12,000 BTUs)
6. Burner "On" Indicator Light
7. Serial Number/Data Plate Location (right front
underneath)
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
WARNING:
To prevent flare-ups and avoid creation of
harmful by-products, do not use the cooktop
without all burner caps and all burner grates
properly positioned.
Sealed Burners
Your new cooktop has sealed gas burners. There are no
burner parts under the cooktop to clean, disassemble or
adjust. Your cooktop has three different burner sizes;
small, medium, and large. Match the corresponding letters
on the burner cap and burner base. See "Burners Caps" on
page 7.
Burner Caps
WARNING:
To prevent burns, do not touch burner caps or
grates while hot. Turn the cooktop off and allow
the burners to cool.
Placing Burner Caps
Each cap has a letter (A, D, or F) cast in the underside of
the cap that corresponds to a letter (A, D, or F) cast in the
burner base that is attached to the appliance.
The burner cap is porcelainized steel. The burner caps
must be properly placed for the cooktop to function
properly. If the burner cap is not properly placed, one or
more of the following problems may occur:
• Burner flames are too high.
• Place each burner cap on its correct burner base per
its corresponding letter designation. See figure
"Burners Caps" on page 7.
• Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
English 6