Publicidad
PROBLEM - CAUSE - SOLUTION
PROBLEM
CAUSE
Power cord not connected to a power
socket.
The machine does not
Power button switched to "0".
switch on.
Machine in power save status.
No water in the tank.
Capsule not inserted in the capsule
compartment.
The capsule inserted does not brew
coff ee.
Incomplete closure of the moving part
The machine does not
of the machine head.
brew coff ee.
or
Water tank not engaged correctly.
Limescale on internal components.
Failure to start the pump.
Wrong capsule type.
The water tank is not correctly and/or
Water leak.
not completely inserted.
The milk kit is not correctly and/or not
completely inserted.
38
Connect the plug to a socket conforming to the technical data indicated in the data plate under the base of the machine.
Switch the power button to "I".
Turn on the machine by touching the
Touch the
or
Fill the tank with water.
Insert a capsule into the capsule compartment.
Remove the capsule by disengaging and lifting the lever and retrieve it from the used capsule tray. Close the capsule
compartment and dispense a small quantity of water. Refi t the capsule and start brewing.
Lift the lever and insert the capsule properly. Lower the moving part and lock it by lowering the lever. Press
to brew coff ee.
button not activated.
Touch the
or
Make sure the tank is fully inserted.
Descale the machine as described in the relevant section.
Try to dispense water with no capsule in the compartment.
Make sure that you have used an "Iperespresso" capsule for domestic use, identifi ed by the wording "Single-dose ground
coff ee capsules for domestic use" on the packaging.
Make sure that the water tank is completely inserted.
Make sure that all the milk kit components have been correctly assembled and inserted.
SOLUTION
or
button.
button again to start brewing.
button again.
Persistence of
the problem
Contact an
authorised
or
service centre.
Publicidad
Capítulos
