Publicidad
Idiomas disponibles
Idiomas disponibles
uirement
For E
c D
hnportant
: Grounding _hrough the neutral conductor
is prohibited tbr (1) new branch_ircuit
installations,
(2) mobile homes,, and (3):recreational
veNcles,, and
(4) areas where local codes prohibit grounding fllrough
the neural
conductor.
Prepare minimmn
5fi (1.52m) of length in order for
dryer to be :replaced..
First, strip 5 inches (12.7cm)of
outer sheath from
end and strip 1 inch of insulation
from each
conductor.
Then, put tile hooked shaN end of the wire under the
screw of fl_e ternfinal block (hooked end facing
rightward) and pinch the hook together and screw tightly.
• if your Mcal codes or ordfllmlces do not allow file
use of a 3 wire connection,
or you are installing
your dryer in a mobile home, you must use a 4-
wire connection.
plug
3/4 in. (1.9 _l
.
UL approvedstrainrelief
1. Comlect neutral wire (white) of power cord to
center terminal block screw.
2. Comlect red mid black wire to the left mid right
terminal block screws.
3. Make sure lhat lhe strain relief screw is lightened
and be sure that all terminal block nuts are on
tight and power cord is ill right position.
Cen_
t_inal
_k
_
{silver)
_
_our_ing
wi_ (wN_)
Ne_I
g_an_
F_xterr_g_nd
_r
Direc>wire
connections
do not meet the
building
code regulations
in most areas, !t is
the customer's
responsibility
to ensure that the
I:_'or_
Ringterminals
--Neutral
.
.
(_ nnect neutral wire (white) of power cord to
center terminal block screw.
C_ nnect :red and black wire to the left and right
terminal block screws.
3. Connect ground wire (green) of power cord m
external ground screw and move neutral ground
wire of appliance
and connect :it m cenmr screw.
4. Make sure that the strain relief screw is tightened
and be sure that all terminal block nuts arc on
tight and power cord is in right position.
Publicidad
