Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Opecation
2.
PuHH bacH(coHHar o n quick-connect
and puHH current
spray tip off. Store spray tips in hoHder provided on the
nozzHe extension.
3.
SeHectdesired spray tip:
For gende rinse, seHect white 40 ° spray tip.
To scour surface_ seHect yeHHowH 5 ° or red 0° spray
tip.
To appHy chemical seHect bHack spray tip.
4.
PuHH bacH< on collar, insert new spray tip and reHease
coHHar.Tug on spray tip to make sure it is secureHy in
pHace.
5.
For most effective
cHeaning, keep spray tip from 8 to
24 inches away from cHeaning surface,
ff you get spray
tip too chose, you may damage cHeaning surface. DO
NOT get cHoser than 6 inches when cHeaning tires.
Now
to Use
tbeTurbo
Nozzle
The turbo
nozzHe rotates
the high pressure
stream
in a
rapid circuHar pattern.AHways
start the turbo
nozzHe at a
distance,
graduaHHygetting
cHoser to the surface
untiH you
get the cHeaning force you want.
CAUTION
. Always make sure the surface you will dean will not be
damagedby the high pressure spray by testing in a hidden area.
H. PuHH bacH(coHHar o n quick-connect
and puHH current
spray tip off. Store spray tips in hoHder provided on the
nozzHe extension.
2.
PuHH bacH<on collar, insert
turbo
nozzHe and reHease
coHHar(Figure
H 6).Tug on turbo
nozzHe to make sure it
is secureHy in pHace.
Now to Use the
Utility
Brush
The utiHity brush allows you to scrub
surfaces
with water
filtering through
the bristHes.
To attach
the
utility
brush
to the spray
gun:
H. Tighten the adapter
to the brush base.
2.
Remove the nozzHe extension
from the spray gun, if
attached.
3.
Attach
the brush with the adapter
to the spray gun.
Tighten
by hand (Figure
H7).
NOTE:
You must use the adapter
to attach
the brush to
the spray gun.
and
Chemical
mNPORTANT:
Use soaps
designed
specificammy for
pressure
washers.
HousehoHd detergents
couHd damage
the pump.
* Starting the engine without all the hoses connected
and
without the water turned ON will damage the pump_
* Damage to equipment resulting from f_ilure to follow this
instruction will void warranty.
To apply
detergent
follow
these
steps:
H.
Review spray tip use.
2.
Prepare
detergent
soHution as required
by manufacturer.
3.
Hang detergent
soHution on "J" hook attached
to
accessory
tray, as shown in Figure HS.
3.
For most effective deaning, keep turbo nozzHe from 8 to
24 inches away from cHeaning surface. If you get turbo
nozzHe too chose, you may damage cHeaning surface.
NOTE:
Detergent
cannot
be appHied with the turbo
nozzHe.
Publicidad
