Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
Z
Secure tray to handle with self tapping screws using a
#2 phillips screwdriver, Ensure screws are tight but not
crushing the plastic accessory tray.
3.
Place handle assembly onto handle supports connected
to main unit. Hake sure holes in handle align with holes
on handle supports (Figure 2).
7.
Pinch chemical hose and slide it into metaH chip as
shown in Figure 5.
Handle
Align Holes/--_
NOTE:
It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4.
[nsert"U'
bolt through hole on right side of handle
(viewing from handle side of unit) and attach plastic
knob.Tighten
knob by hand (Figure 3).
5.
6.
G
Insert carriage bok through left side hole from outside
of unit and attach a plastic [<nob from inside of unit
(viewing unit from the handle side).Tighten
by hand
(Figure 3).
Insert "J" hook into second from left slot in accessory
tray (Figure 4).
8.
Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 6). Slide
chemical hose through
metal clip so that it is tight but
not kinked.
Add
Ensine
Oi[
and
Fuel
° Place pressure washer on a [eve[ surface.
, Refer to engine owner's manual and follow oil and fuel
recommendations
and instructions.
• Refer r_o engine manual for oil and fuel fill information.
• Damage so equipment
resuking from failure to follow
this
instruction
will void warranty.
NOTE:
Check
oil often
during
engine
break-in,
Refer to
engine
owner's
manual
for
recommendations,
O
Publicidad
