GE 23 Manual Del Propietario E Instalación página 12

About the automatic icemaker.
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemoker
On dispenser models,
to access ice or reach
the power switch:
o Lift the bin, then pull it
forward until the bin stops.
o Lower the bin to access ice
or reach the power switch.
NOTE: In order to take full
advantage of the tilt-out ice bin,
only store items on the shelf below
the ice bin that are no taller than
the lowest point on the bin.
The icemaker will produce seven cubes
per cycle-approximately
100-130cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the OFFposition.
When the refrigerator has been connected
to the water supply, set the power switch
to the ON position.
The icemaker will fill with water when it cools
to 15°F (-10°C). A newly installedrefrigerator
mag take 12 to 24 hours to begin making
ice cubes.
Special note about dispenser models:
:_:_ D ispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in the
illustrations, and it will hold itself up while
you take ice out or turn the icemaker
power switch on and off. Be sure to put the
bin back in place before closing the dooE
:i :_ T o restore your ice level from an empty
bucket stage, the following steps are
recommended:
O 12 hours after the first batch of ice has
fallen into the bin, dispense Bto 4 cubes.
After an additional 6 hours, dispense
B to 4 cubes again.
These steps will restore your ice levelin
the shortest amount of time.
You will hear a buzzing sound each time
the icemaker fills with water
Throw awag the first few batches of ice
to allow the water line to clear
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes to bejoined
together
!cemaker
Switch FeelerArm
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink.
o Lift the bin. then oull it
forward until the bin stoos.
Removing Ice Bin
(dispenser
models)
CAUTION:The ice bin is heavy when full....................................................................................................
Set the power switch to the OFFposition
before removing the bin.
When replacing the bin, be sure to press
it firmly into place. If it does not go all the
wag back, remove it and rotate the drive
mechanism 1/4 turn. Then push the bin
back again.
Dispenser Models only
O Lift andpull forward again
to remove the bin.
12