GE 23 Manual Del Propietario E Instalación página 17

Trim kits and decorator panels.
For CustomStgld" models
Read these instructions completely and carefully.
Before You Begin
Some models ore equipped with trim kits that allow you to install door panels. You con order
pre-cut block, white, bisque or stainless steel decorator panels from GE Ports and Accessories,
800.626.2002, or you con odd wood panels to match your kitchen cabinets.
Panels less than 1/4" (6 mm) thick
When installing wood panels less then 1/4" (6 mm) thick, you need to create a filler panel, such as 1/8"
cardboard, that will fit between the face of the door and the wood panel, If Uou are installing the pre-cut
decorator panels, pre-cut filler panels are included in the kit, The combined thickness of the decorator
or wood panel and the filler panel should be 1/4" (6 mm),
Panels1/4" thickor less
i/4" max
3/4" (19 mm) or Raised Panel
A raised panel design screwed or glued to a 1/4" (6 mm) thick backing, or a 3/4" (19 mm) routed board can
be used. The raised portion of the panel must be fabricated to permit clearances of at least 2" (5.1 cm) from
the handle side for fingertip clearance.
Panels thicker than 1/4" (6 mm), up to 3/4" (19 mm) max, will require that the outer 5/16" (8 mm) of panel
perimeter be no thicker than 1/4" (6 mm).
Weight limitations for custom panels:
Fresh Food38 lbs. (17 kg) max.
Freezer Door 28 lbs. (13 kg) mex.
Panelsthicker than 1/4" (6 mm)
1/4" (6 mm)
Thick Backing
5/16" (8 ram)
1/4"(6 mm) max
3/4"(19mm)
¢"
2" (5.1 cm)
Clearance
Handle Side
Appearance
Panel
(19 mm)
Refrigerator
Door
17