Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
Pitch-control knob
Speed selector
Single-play spindle
Cartridge holder
Tonearm rest
(8) Tonearm eue-control height adjustment
7) Stylus force adjustment
(8) Tonearm counterbalance
@® Anti-skating force adjustment
© Cue-control
® Tonearm lock
® Tonearm set-down adjustment
Record size selector
Operating switch for automatic
start and stop
®© Chassis hold-down screw (for transport)
Tonearm l i
and lock
@® Multiple-play spindle AW 3
® Adapter for large-hole records
® Multiple-play spindle AS 12 for large-hole
records (special accessory)
Operation in single-play mode
Insert the short,
single-play spindle (and,
for 45 rpm records, the center-hole adapter)
then place the desired record on the platter,
Fig. 6
Select the appropriate turntable speed @
set the record size selector @ to 7", 10" or
12" resp, (17, 25 or 30 cm), depending on the
size of the record you want to play, and
unlock the tonearm (Fig, 7)
Now the unit is ready to play.
The smoothly functioning operating control
select the correct function for automatic
single-play or record-changing operation.
Fig. 7
1. Automatic start
Push the operating switch to "start".
The
motor will start, the tonearm will rise, move
to the record, then descend onto the record
N
1216
q
œ
2. Automatic start with cue-control
First move the cue-control lever to Y, then
push the operating switch to
start",
The
tonearm will descend very slowly and land
on the record without jarring it the
slightest,
controlled by the silicone damping of the
cue-control system
3 . Manual start
Place the tonearm on the record by hand
(As you move the tonearm from the rest
post toward
the record,
the platter
begin to rotate.)
4. Manual start with cue-control
a) Move the
cue-control lever to position Y,
b) Move the tonearm by hand over the
desired spot on the record.
c) Lightly
tap the lever back
to Y. (The
tonearm will descend.)
5,
To repeat a record
Push the operating switch to "start"
6. To interrupt play
Move the cue-control to Y,
7, To resume play where it was interrupted
Move
the
cue-control
lever
to
(A
light
tap
will
do.)
The
tonearm
will
descend
and
repeat a few grooves.
8. To stop
Move the operating switch to "stop",
The
tonearm will return to its rest and the
motor will shut off.
Note: After a single record has played, or
after the last record in a stack has played,
the tonearm will return automatically to its
rest and the motor will shut off. It is advis-
able then to lock the tonearm on its rest
(Fig. 7)
Operation in multi-play mode
Insert either the conventional changer (long)
spindle or the
one for large-hole
45 rpm records*,
so that the key slips into
the corresponding slot in the shaft,
Lock
the spindle in place by pressing down on it
as you turn it to the right, until it stops,
Fig. 10
Stack up to six records of the same size
and speed on the multiple-play spindle or
the special one for large-hole 45 rpm records,
Publicidad
