Silvercrest SSB 1000 A1 Instrucciones De Uso página 39

Charging the battery
The device has a built-in battery. It can be used in mains operation or
in battery mode. It takes around 4 hours to fully recharge an empty
battery.
♦ Plug the device into a power socket. The charging LED
up red during charging.
♦ When the charging LED
and the device can be used in battery mode.
♦ If the charging LED
Handling and use
Switching the device on/off
♦ Press and hold down the
lights up) to switch on the device. The device switches on in the
operating mode that was used last.
♦ Press and hold the
The operating LED
of beeps.
NOTE
► After it is switched off, the device remains in standby. As the device
still consumes power in this mode, we recommend charging the
battery at regular intervals to increase the lifespan of the battery.
Adjusting the volume
♦ Press or hold the
the volume. When you reach the maximum or minimum volume
you will hear a short beep.
│ GB │ IE
■ 36
goes out, the battery is fully charged
flashes red, the battery is nearly empty.
button
button again to switch off the device.
will go out. You will hear a rising series
or buttons to increase or decrease
(until the operating LED
SSB 1000 A1
lights