DeWalt DWS535 Manual De Instrucciones página 11

arbor c enter isexposed. Only blades withadiamond-shaped arbor
center canbeused onthissaw.
NOTICE: Never install a blade without removing the knockout. Lack
of blade engagement will cause the blade to come into contact with
other parts of the saw causing tool damage.
TO REMOVE KNOCKOUT
_ WARNING:ALWAYS use eye protection. All users and bystanders
must wear eye protection that conforms to ANSI Z87.1.
_, WARNING: Make sure that bevel adjusting locking lever is tight and
secure after using it to remove knockout, ff blade adjustment shifts
while cutting it may cause binding and kickback.
FIG. 9
4.
freely and does not touch the blade, foot plate or any other part,
in all angles and depths of cut.
Place blade (T) on saw spindle (U) against the inner clamp
washer (V), making sure that the blade will rotate in the proper
direction (the direction of the rotation arrow on the saw blade
and the teeth must point in the same direction as the direction of
rotation arrow on the lower blade guard).
IMPORTANT: Always ensure the diamond-shaped arbor center
of the blade aligns with the raised diamond-shaped arbor center
on the outer clamp washer.
FIG. 10 J
C
Q
Place the round center hole of the blade into the notch (Q) on the
top of the bevel adjustment lever (H). Grasping the saw and blade
firmly, pull until the knockout pops out. The diamond-shaped arbor
center is now exposed.
TO INSTALLTHE BLADE (FIG. 1, 10, 11)
1. Loosen and remove the blade clamping screw (R) with the
wrench provided, by turning it clockwise as indicated by the
arrow on the outer clamp washer (S).
2. Remove outer clamp washer (S).
3. Using the lower blade guard retracting lever (C), retract the lower
blade guard (E).
IMPORTANT: When retracting the lower blade guard to install
the blade, check the condition and operation of the lower blade
guard to assure that it is working properly. Make sure it moves
V