MTD 11A-B2M7309 Manual Del Operador página 10

Cutting Height Adjustment
There are two cutting height adjustment configurations. Refer to
the section applicable to your mower.
SINGLE LEVER (IF EQUIPPED)
The single lever cutting height adjustment is located above the
rear left wheel (Figure 15).
1. Carefully pull the height adjustment lever outward towards
wheel (mower will tend to fall when lever is moved outward).
2. Move lever to desired position for a change in cutting height.
3. Release lever towards deck.
Higher
Figure 15
DUAL LEVER (IF EQUIPPED)
The dual lever cutting height adjustment levers are located
above the front and rear right wheel (Figure 16).
1. Carefully pull the height adjustment lever outward towards
wheel (mower will tend to fall when lever is moved outward).
NOTE: The front and rear height adjustment levers move in
the opposite direction to adjust.
2. Move lever to desired position for a change in cutting height.
3. Release lever towards deck.
IMPORTANT: To avoid uneven cutting, all wheels must be placed
in the same cutting height position. For rough or uneven lawns,
move each height adjustment lever to a higher position. This will
prevent you from cutting the grass too close to the ground.
Lower
1
Higher
3
Figure 16
ADJUSTMENTS
2
Lower
3
1
2
2
Higher
Lower
1
3
Handle Pitch Adjustment (If Equipped)
For convenience of operation, you may adjust the pitch of the
handle. Perform one of the following.
PULL-OUT HANDLES
1. Remove two knobs or wing nuts and carriage bolts from
handle (Figure 17).
2. Position the handle in one of the three positions that is most
comfortable. See inset, Figure 17.
3. Secure into position with two knobs or wing nuts and
carriage bolts removed in Step 1.
1
VERTICAL STORAGE HANDLES
1. Unlock the two handle release levers. See inset, Figure 18.
2. Move the upper handle to align the position indicator with
the most comfortable of the three handle positions.
3. Lock the two handle release levers. See inset, Figure 18.
Unlock
Lock
10
2
Knobs
Shown
Figure 17
c
b
Figure 18