Side Handle - Skil 9295 Instrucciones De Funcionamiento Y Seguridad

SM 2610008537 11-09:SM 2610008537 11-09 11/12/09 8:33 AM Page 9
WHEEL GUARD INSTALLATION
Use wheel guard with disc
W RNING
grinding wheels. Always
close the latch to secure the guard. Keep the
guard between you and the wheel. Do not
direct guard opening toward your body.
The position of the guard can be adjusted to
accommodate the operation being performed.
To attach wheel guard DISCONNECT tool
from power source.
Open guard release/lock latch and position
guard on spindle neck so that the three bumps
on guard, line up with the three notches on the
spindle neck (Fig. 2).
Rotate guard either direction to desired
position, and close latch to secure guard in
place. Note: If lock latch does not securely
clamp the guard to the spindle neck, open
latch and tighten adjustment screw to increase
clamping tension.
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded spindle
for mounting accessories. Always use the
supplied lock nut (and backing flange) that
has same thread size as spindle.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure
that wheel guard is in place for grinding.
Place BACKING FLANGE and GRINDING
WHEEL on the spindle. Thread on the lock
nut and tighten nut using the supplied lock
nut wrench, while holding the spindle lock in
(Fig. 3).
TO REMOVE: Reverse procedure.
GRINDING
WHEEL
Assembly
TO REMOVE
release/lock latch, rotate guard until the bump
on guard lines up with the notches on the
spindle neck, and lift guard off the spindle
neck.
FIG. 2
SPINDLE
NECK
NOTCHES
DJUSTMENT
SCREW
The side handle used to guide and balance the
tool can be threaded into the front housing on
either side of the tool, depending on personal
preference and comfort. Use the side handle
for safe control and ease of operation.
SPINDLE
SPINDLE
B CKING
FL NGE
LOCK NUT
-9-
GUARD: Open
WHEEL
BUMPS
GU RD
GU RD
RELE SE / LOCK
L TCH

SIDE HANDLE

WHEEL
GU RD
B CKING
FL NGE
GRINDING
WHEEL
LOCK NUT
guard
FIG. 3