Descargar Imprimir esta página

KlipXtreme STYLE Manual Del Usuario página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

BUILT-IN BATTERY CARE
• This product is powered by a rechargeable battery. The full performance of a
new battery is achieved only after two or three complete charge and discharge
cycles.
• The battery can be charged and discharged hundreds of times, but will
eventually wear out. Do not leave a fully charged battery connected to charger,
since overnight charging may shorten its lifetime.
• Unplug the charger from the electrical plug and product when not in use.
• If left unused, a fully charged battery will lose its charge over time.
• Leaving the product in hot or cold places such as in a closed car in the summer
and winter conditions, will reduce the capacity and lifetime of the battery.
• Always try to keep the battery between 15 and 25 degrees Celsius (59 and 77
degrees Fahrenheit). A product with a hot or cold battery may not work
temporarily, even when the battery is fully charged.
• Charge/power the headset according to the instructions supplied with the
product.
Technical specifications
MPN
Headphone
Form factor
Driver unit
Maximum power output
Frequency
Signal-to-noise ratio
Impedance
Sensitivity
Microphone
Form factor
Directivity
Frequency
Impedance
Sensitivity
Connectivity
Connection type
Bluetooth
audio connector
Wireless RF frequency
2.402GHz—2.480GHz
Wireless range
Up to 66ft*
Bluetooth
profiles
- Supports the V5.0 specification
®
- A2DP v1.2
- AVRCP v1.4
- HFP v1.6
- HSP v1.2
- DI v1.3
KWH-750
On ear
40mm
20mW per driver
100Hz-20,000Hz
80dB
32Ω ± 15%
119 ± 3dB/mW (S.P.L at 1kHz)
Built-in on left capsule
Omnidirectional
100Hz-18,000Hz
680Ω
-42dB ±3dB at 1kHz
®
V5.0 and 3.5mm

Publicidad

loading

Este manual también es adecuado para:

Kwh-750