Hama Black Line Plus Instrucciones De Uso página 8

(Manual) settings
• Press and hold the
seconds to make the following settings one after the
other:
• Year
• Month and date display
• Month
• Day
• Hour
• Minute
• 12-/24-h format
• Time zone
• °C and °F display
• Language
• hPa and inHg display
• To select the individual values, press the
or the button (C), and con rm each selection by
pressing the button (A).
• Press the button (A) immediately to adopt the set
value displayed and skip ahead.
• If you do not make an entry for 20 seconds, Settings
mode is exited automatically.
Note – Time zone
• The DCF signal can be received over long distances,
but always transmits the current Central European
Time in Germany. Make sure you account for the time
difference in countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in
Germany. This means that you should set +3 for the
time zone. The clock then automatically sets the time
to 3 hours after the DCF signal received or relative to
the manually set time.
Note – Day of the week
You can choose from German (GER), English (ENG),
French (FRE), Italian (ITA), Spanish (SPA), Dutch (DUT)
and Danish (DAN) for the day of the week display.
7
button (A) for approximately 3
button (B)
Alarm
• You can set two separate alarm times,
• Press the button (A) to display the alarm time.
• Press and hold the
to set the signal time of the alarm displayed. The hours
display begins to ash.
• Press the button (B) or the
the hour for the alarm time and con rm your selection by
pressing the button (A). The minutes display begins
to ash.
• Repeat the process to set the minutes for the alarm time.
• Repeat this process for the second alarm time.
• If you do not make an entry for 20 seconds, Settings
mode is exited automatically.
• If the alarm is triggered, the alarm symbol will begin to
ash and an alarm will sound.
• Press any button (except the SNOOZE/ LIGHT button (F))
to stop the alarm. Otherwise, it will stop automatically
after 2 minutes.
• The alarm does not need to be reactivated. It will trigger
again at the set alarm time 24 hours later.
Enabling/disabling the alarm
• To select and activate or deactivate the appropriate
alarm, press the button (D) repeatedly to select
or . An active alarm is displayed by the alarm symbol
or . When an active alarm is deactivated, the
corresponding alarm symbol
• When the alarm is triggered, the active alarm symbol (5)
begins to ash and an alarm sounds. Press any button
(except the SNOOZE/LIGHT sensor (F)) to stop the alarm.
Otherwise, it will stop automatically after 2 minutes.
Note – Snooze function
• While the alarm signal is sounding, press the
SNOOZE/LIGHT button (F) to activate the snooze
function. The alarm signal will stop for 5 minutes,
after which it will sound again.
• Press any button (except the SNOOZE/LIGHT button
(F)) to stop the snooze function and the alarm.
and .
button (A) for approx. 3 seconds
button (C) to select
or disappears.