Craftsman WEEDWACKER INCREDI-PULL 316.796140 Manual Del Usuario página 3

• Use the unit only in daylight or good artificial light.
• Avoid accidental starting. Be in the starting position
whenever pulling the starter rope. The operator and unit
must be in a stable position while starting. Refer to
Starting/Stopping Instructions.
• Use the right tool. Only use this tool for its intended purpose.
• Do not overreach. Always keep proper footing and balance.
• Always hold the unit with both hands when operating. Keep
a firm grip on both handles or grips.
• Keep hands, face, and feet at a distance from all moving parts.
Do not touch or try to stop the cutting attachment when it rotates.
• Do not touch the engine, gear housing or muffler. These
parts get extremely hot from operation, even after the unit is
turned off.
• Do not operate the engine faster than the speed needed to
cut, trim or edge. Do not run the engine at high speed when
not cutting.
• Always stop the engine when cutting is delayed or when
walking from one cutting location to another.
• If you strike or become entangled with a foreign object, stop
the engine immediately and check for damage. Do not
operate before repairing damage. Do not operate the unit
with loose or damaged parts.
• Stop the unit, switch the engine to off, and disconnect the
spark plug for maintenance or repair.
• Use only replacement parts or accessories recommended for
this tool that are distributed by Sears or a Craftsman outlet.
Use of any replacement parts or accessories purchased
elsewhere may be hazardous, and will also void your warranty.
• Keep unit clean of vegetation and other materials. They may
become lodged between the cutting attachment and shield.
• To reduce fire hazard, replace a faulty muffler and spark
arrestor. Keep the engine and muffler free from grass, leaves,
excessive grease or carbon build up.
OTHER SAFETY WARNINGS
• Never store the unit with fuel in the tank, inside a building
where fumes may reach an open flame (pilot lights, etc.) or
sparks (switches, electrical motors, etc.).
• Allow the engine to cool before storing or transporting. Be
sure to secure the unit while transporting.
• Store the unit in a dry area, locked up or up high to prevent
unauthorized use or damage, out of the reach of children.
• Never douse or squirt the unit with water or any other liquid.
Keep handles dry, clean and free from debris. Clean after
each use, see Cleaning and Storage Instructions.
• Keep these instructions. Refer to them often and use them to
instruct other users. If you loan someone this unit, also loan
them these instructions.
SAVE THESE INSTRUCTIONS
SAFETY AND INTERNATIONAL SYMBOLS
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the
operator's manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING
SAFETy ALERT SYMBOL
Indicates danger warning or caution, May be used
in Conjunction with 0ther symbols or pictographs.
; WARNING, READ OPERATOR'S MANUAL
mJJ I JIm Readthe 0perator!smanual(s)andfoIIgwallwarnings
and Safetyinstructions,Failur e to do S° can resultin
setous n ury to the operatorand!or bystanders.
_l_hlL ' WEAR EYE AND HEARING PROTECTION
I[_llk_llrm=ql_m WARNiNG:Thrown objects and loud noise Can
_WJ cause severe eye injury and hearing loss. Wear eye
protection meeting ANSI Z87:1 standards and ear
protection when 0perating this unit. Use a full face
shield when needed.
SURFACE WARNIN G
Do not touch a hot muffler,gear housing or cylinder.
You may get burned. Theseparts get extremely hot
,}_}_/II_l_))/i, from 0perat!on.They remainhot for a short time after
the unit is turned off.
N_ ' UNLEADED FUEL
_ Always uSe clean I !resh unleaded rue!
_U
,OiL
_ Refer t0 0perater s manual for the pr0Per type of
oil.
SYMBOL
A
MEANING
• KEEP BYSTANDERS AWAY
WARNING: Keep all bystanders, especially
children anc Nets. at least 50 feet (15 m) from the
operating area.
_, . ._ • CHOKE CONTROL
Pt P-I .
1. FULL choke oosit_on
2. • PARTIAL choke position
3. • RUN choke position
• THROWN OBJECTS AND ROTATING CUTTER
CAUSE SEVERE INJURY
_IG: Do not operate without the cutting
attachment shield in olace. Keep away from me
rotaung cutting attachmen]
_1_ • SHARP BLADE
WARNING: Sharp blade on cutting attachment
shield. To prevent serious injury, do not touch the
ine cutting blade.
i • ON/OFF STOP CONTROL
ON / START / RUN
• ON/OFF STOP CONTROL
OFF or STOP