Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing/Replacing the lamp
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need a 230 V/300 W GX-6.35 lamp.
During the operation, the lamp reaches temperatures of up to 775° C.
Procedure:
Step 1: Unscrew the fixation-screws of the housing-ball.
Step 2: Remove the upper part of the ball.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Put the new 230 V/300 W GX-6.35 lamp into the lamp-socket.
Step 5: Replace the upper part of the ball and tighten the screws.
Rigging
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the ground or on the wall or ceiling.
Hanging installation
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened housing-ball!
DANGER OF FIRE!
15/32
00026430.DOC, Version 5.0
Publicidad
