Atlas Copco LZB33-L-AR005-50 Información Seguridad página 5

LZB33-L-AR005-50
Hot Spots
The following hotspots on the motor (as seen in the figure)
can reach high temperatures during operation:
• Seal ring at the output shaft
• Joint between front part and gear ring
• Key grip
Illustration 1: Straight models
Illustration 2: Angled models
The highest temperatures occur when the motor is running at
full pressure without load. With increasing torque, the air mo-
tor reduces the rotational speed and the temperature.
© Atlas Copco Industrial Technique AB - 9834 4191 00
Warning
Make sure you are familiar with the operating instructions be-
fore you use this motor.
This motor, its attachments and accessories must only be used
for the purpose for which they were designed.
For product liability and safety reasons any modification to
the motor or its accessories, which may have an influence on
the product liability, must be agreed upon by the technical au-
thority of the manufacturer.
To prevent personal injury and long term risks:
• If the motor is ATEX-certified, filter/silencers must be in-
stalled at the motor outlet ports.
Silencers are recommended also for other applications to
reduce noise exposure.
• Disconnect the motor from the air line before any adjust-
ment operation.
• Mind your hands, hair and clothing – always keep
well away from rotating parts.
General safety instructions
To reduce risk of injury, everyone using, installing, repairing,
maintaining, changing accessories on, or working near this
tool must read and understand these instructions before per-
forming any such task.
Our goal is to produce tools that help you work safely and ef-
ficiently. The most important safety device for this or any tool
is YOU. Your care and good judgment are the best protection
against injury. All possible hazards cannot be covered here,
but we have tried to highlight some of the important ones.
• Only qualified and trained operators should install, adjust
or use this power tool.
• This tool and its accessories must not be modified in any
way.
• Do not use this tool if it has been damaged.
• If the rated speed, operating pressure or hazard warning
signs on the tool cease to be legible or become detached,
replace without delay.
For additional safety information consult:
• Other documents and information packed with this
tool.
• Your employer, union and / or trade association.
• Further occupational health and safety information
can be obtained from the following web sites:
• http://www.osha.gov (USA)
• https://osha.europa.eu/ (Europe)
Air supply and connection hazards
• Air under pressure can cause severe injury.
• Always shut off air supply, drain hose of air pressure and
disconnect tool from air supply when not in use, before
changing accessories or when making repairs.
• Never direct air at yourself or anyone else.
• Whipping hoses can cause severe injury. Always check
for damaged or loose hoses and fittings.
Safety Information
5