Publicidad
Idiomas disponibles
Idiomas disponibles
Electric Motor
Model
Continuous Rated Power
C35
350 W
Maintenance
• Always inspect product before riding and regularly maintain it. Replace worn or damaged parts immediately.
• Check that the steering system is correctly adjusted and that all connection components are firmly secured and not broken.
• Check brake for proper function. When you press on the electronic brake (on handlebar with your finger) or step on the rear-fender brake
with your foot, brake should provide positive braking action.
• Under normal circumstances and conditions, the wheels and bearings are maintenance free.
• Regularly check that the various screwed parts are tight.
Nut Diameter (mm)
Suggested Torque (N/M)
5 mm
6 mm
8 mm
10 mm
12 mm
• No modifications can be made that can impair safety.
• Wipe with a damp cloth to remove dirt.
• Use only authorized Razor replacement parts.
WARNING: As with any mechanical component, an electric scooter is subject to high stresses and wear. The various materials and
components may react differently to wear or fatigue. If the expected service life for a component has been exceeded, it may break suddenly,
therefore risking causing injuries to the user. Cracks, scratches and discoloration in the areas subject to high stresses indicate that the
component has exceeded its service life and should be replaced.
Storage
Prolonged exposure to UV rays, rain and the elements may damage the enclosure materials; store indoors when not in use.
Failure to use common sense and heed the above warnings further increases risk of serious injury. Use at your own risk and with
appropriate and serious attention to safe operation. Use caution.
Li-ion
CONTAINS LITHIUM-ION BATTERY PACK. BATTERIES MUST BE RECYCLED.
UL 2271 COMPLIANT
Li-ion
How to Ride
Do not activate the thumb throttle unless you are on the C35 and in a safe, outdoor environment suitable
for riding.
Put kickstand up.
Press the power button (A) for two seconds, the LEDs on the battery display will light up. Press the power
button (A) for two seconds again to turn the unit off.
Headlight and Taillight: To activate the headlight and taillight the product must be powered ON. Press
the power button (A) once to activate the headlight and taillight. To deactivate the headlight and
taillight, press the power button once again.
Get on the scooter and place both hands on the handlebars. Kick to start (B), and then push the thumb
throttle (C).
A
Voltage
(Nominal) Vdc
37
5~6 N/M
9~12 N/M
22~30 N/M
45~59 N/M
78~104 N/M
B
Capacity
Charge
(Nominal) Ah
Temperature Range
0° to 40°C
7.5
32° to 104°F
C
9
Operating
Temperature Range
-20° to 40°C
-4° to 122°F
NOTE: Electric scooter must be
moving at least 5 km/h (3 mph)
while engaging throttle to
engage motor.
Speed Mode
Speed
Battery Capacity
Publicidad
