Publicidad
Idiomas disponibles
Idiomas disponibles
Using and Setting Cruise Control
The C35 electric scooter features Cruise Control. While activated, this feature will automatically keep your electric scooter running at a set
speed. This allows you to ride without having to constantly press on the thumb throttle. Practice in an open area free from obstacles until
you are familiar with the cruise control feature. Note: The C35 is shipped with the cruise control feature deactivated from the factory. When
turning the electric scooter power ON, the letters NC (No Cruise) will appear on the display showing that the cruise control feature is not
enabled.
How to Enable Cruise Control Mode and Set the Speed
1 The cruise control mode is controlled by
the power button on the display (A).
3 The electric scooter must be traveling at least 6 mph (9.7 km/h) to set cruise control speed. To set a constant speed, press the throttle (C)
and ride your scooter until you reach your desired speed — then hold the throttle at that speed for eight (8) consecutive seconds. The electric
scooter will beep (sound) once and the cruise control icon (D) will appear on the display, indicating that the electric scooter is now set at the
desired speed. Once set, you can take your thumb off the throttle and your electric scooter will maintain that set speed. Pressing any control
such as the throttle, e-brake or rear-fender brake will deactivate the speed setting and the cruise control icon (D) will dissapear
from the display. Your speed setting will not be saved and you will need repeat step 3 to reset to your desired speed.
Note: Once the electric scooter is powered OFF, cruise control mode will be disabled. To use the cruise control feature, the cruise
control mode must be enabled (following steps 1-3 above) each time you power ON your electric scooter.
How to Disable Cruise Control Mode
To manually disable the cruise control mode, press the power button (A) quickly four (4) times. The
electric scooter will then beep (sound) once and the display will show the letters NC (No Cruise) for
a few seconds (E).
A
2 While stationary, to enable the cruise control mode, press the power button (A) quickly
four (4) times. The electric scooter will then beep (sound) once and the display will show the
letter C (Cruise) for a few seconds (B).
C
A
A
E
11
B
D
Publicidad
