Makita RF1100 Manual De Instrucciones página 5

Switch action
For RF1100 and RF1101
ON
OFF
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply cau-
tion when locking tool in "ON" position and maintain
firm grasp on tool.
To start the tool, move the switch lever to the I (ON) posi-
tion. To stop the tool, move the switch lever to the O
(OFF) position.
For RD1100 and RD1101
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply cau-
tion when locking tool in "ON" position and maintain
firm grasp on tool.
After connecting the motor unit cord to the outlet in the
handle, move the switch lever to the "ON" position.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
003661
1. Switch lever
1
003663
1. Motor unit cord
1
2. Outlet
3. Lock button
4. Switch trigger
2
3
4
Speed adjusting dial
For model RF1101 and RD1101 only
The tool speed can be infinitely adjusted between 8,000
and 24,000 rpm by turning the speed adjusting dial on
the top of the tool. Higher speed is obtained when the
dial is turned in the direction of number 6; lower speed is
obtained when it is turned in the direction of number 1.
This allows the ideal speed to be selected for optimum
material processing, i.e. the speed can be correctly
adjusted to suit the material and bit diameter.
CAUTION:
• If the tool is operated continuously at low speeds for
a long time, the motor will get overloaded, resulting
in tool malfunction.
• The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or the
speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
CAUTION:
• Do not tighten the collet chuck without inserting a
bit, or the collet chuck will break.
• When using bit of bigger than 1-1/4" in diameter,
install base plate with center hole diameter 2-1/2",
replacing the original base plate.
First, remove the motor unit from the base as follows.
1. Open the lock lever.
2. While holding the base, turn the motor unit counter-
clockwise.
3. Turn it until the pin in the base is disengaged from
the groove in the motor unit. Lift the motor unit free
from the base.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
5
003672
1. Lock lever
1