Changing The Blade - QEP 83200Q Instrucciones De Funcionamiento

5 . Pull the motor trolley slowly towards the
material to be cut (Fig 12) .
fIgurE 12
6 . When you have completed the cut push motor
trolley/blade away and remove the cut pieces,
and any debris on cutting surfaces .
maKinG a diaGOnaL CUt
1 . Follow the same procedure for a straight cut .
2 . Loosen the nut on the squaring tool, and
position the tile diagonally .
3 . Lock the nut and perform the cut following
procedure for a straight cut .
anGLed Or 45 deGree CUtS
1 . Loosen the two knobs at either end of the
bridge (Fig 13) .
fIgurE 13
2 . Tilt bridge to the desired angle up to 45 degrees
(Fig 14) . Tighten knobs at either end of bridge,
and proceed with cutting tile following same
procedure as listed in the "straight cut"
section .
fIgurE 14

CHanGinG tHe BLade

THE POWER SUPPLY BEFORE MAkING
ADJUSTMENTS, MAINTENANCE, CLEANING
OR REPLACING THE BLADE!
1 . choIcE of ThE SAW bLAdE. Only use 8
Inch continuous rim or turbo blades with a
5/8 Inch arbor .
2 . rEpLAcIng ThE SAW bLAdE
A . First, press the blue rings on the water
hose connector and remove the water
tubes (Fig 15) .
fIgurE 15
B . Remove the blade guard by removing the
2 screws (Fig 16) .
– 8 –
DISCONNECT